double balance unbalance gas lubricated agitator reactor seals
double balance unbalance gas lubricated agitator reactor seals

DOUBLE AGITATOR MECHANICAL SEALS

Type RT-83/83B

  • Balance Pusher Seals.
  • Dry Run Seals are excellent in High Speed Seals for Operation in Vacuum Conditions.
  • Without Bearing OR with Integral Bearing.
  • Multiple Spring externally Mounted Seal with ‘O’ Ring as Secondary Sealing member.
  • Various Elastomers can be offered for various media application

Description

Double Agitator Mechanical Seals are modular cartridge seal for use in a wide variety of mixing and agitating equipment and covering a broad application range. These seals are wet running heavy duty cartridge double seal. The Universal Vessel Seal uses modular hardware which provides maximum interchangeability. The seal is reverse pressure balanced and will remain closed in the event that barrier gas pressure is lost. These seals Design for using either without bearing (RT-83) or with integral bearing (RT-83B). Special designs and material options available on request.

We also manufacture and supply Single Agitator Seals, Single Dry Agitator and Glass Lined Reactor Mechanical Seals as being top most mechanical seal manufacturers in Mumbai as well as known as one of the most precise mechanical seal manufacturing companies in India.

FAQ

  • It seals the rotating shaft of agitators, mixers and reactors.
  • It uses two sealing faces with a barrier/buffer fluid between them.
  • It is suitable for applications where better leakage control and process protection are required.
  • Choose a double seal when the process fluid is hazardous, abrasive, toxic or difficult to seal.
  • It is also preferred when additional cooling or lubrication of the seal faces is required.
  • The final selection depends on the media and operating conditions.
  • Check shaft diameter, pressure, temperature and agitator RPM.
  • Specify the process media and its characteristics.
  • Also confirm the seal chamber dimensions and existing seal arrangement.
  • Inspect and clean the shaft and seal chamber before installation.
  • Set the seal according to the specified installation dimensions.
  • Connect the barrier/buffer fluid lines correctly.
  • Check shaft alignment and test for leakage before normal operation.
  • Yes, replacement seals can be supplied according to your existing seal or agitator.
  • Share the shaft size, old seal dimensions, model number, photo or drawing.
  • The replacement can be selected according to pressure, temperature, RPM and process media.

Shaft Dia. : 25mm to 150mm

Pressure : Full Vacuum to 30 bar

Temperature : -30°Cto260°C

Speed : 400 RPM

Seal Ring Faces : Carbon and SiC

Seat Faces :SiC and TC

Elastomer : Viton, TTV, FEP and FFKM

MOC : SS 316 – CHANGE OF MOC ON REQUEST