Double Cartridge Mechanical Seals
Double Cartridge Mechanical Seals

DOUBLE CARTRIDGE MECHANICAL SEALS

Type RT-S63

  • Balance pusher seals.
  • Single and dual configuration.
  • Dual directional.
  • Mechanical seal drive to reduce slippage on shaft or sleeve.
  • Hydraulically balance seal for higher pressure & generate low heat on faces.
  • Flushing ports for uniform face cooling.
  • Unitized, Easy-to-fit design.

Description

Seal Type RT-S63 is double cartridge mechanical seal. Double Cartridge balance Seal are Recommended for Clean and dirty media application that can tolerate reversal pressure.This Type of Seals is designed for using for Petroleum Products, Low Aggressive Chemicals and Refrigerants in Centrifugal pumps and other Equipment with Rotating Shafts.It is straight forward and easy installation. Extended service life. Customer specific versions available.

We also manufacture and supply Single Cartridge Mechanical Seals, High Pressure & Speed Balance and Balanced Cartridge Mechanical Seals as being top most mechanical seal manufacturers in Mumbai as well as known as one of the most precise mechanical seal manufacturing companies in India.

FAQ

  • It seals rotating shafts in pumps and industrial process equipment.
  • It has two sealing faces with a barrier or buffer fluid between them.
  • It is suitable for applications where improved leakage control is required.
  • For hazardous, toxic, abrasive or difficult-to-seal fluids.
  • When additional lubrication or cooling of the seal faces is required.
  • It can also be used where minimizing process-fluid leakage is important.
  • Check shaft size, pressure, temperature and RPM.
  • Specify the process fluid and its chemical characteristics.
  • Seal chamber dimensions and barrier-fluid conditions should also be considered.
  • Clean and inspect the shaft and seal chamber before installation.
  • Install the pre-assembled cartridge according to the specified setting dimensions.
  • Connect the barrier/buffer fluid system correctly.
  • Check alignment and leakage before starting normal operation.
  • Yes, replacement seals can be selected according to your existing seal or equipment.
  • Share the brand, model number, shaft size, dimensions, photo or drawing.
  • The replacement can be matched according to the fluid, pressure, temperature and RPM.

Shaft Dia. : 10mm to 100mm

Pressure : Up to 35 bar

Temperature : -30°C to 260°C

Speed : 3000 RPM

Seal Ring Faces  : Carbon, TC and SiC

Seat Faces           : Carbon, SiC and TC

Elastomer            : Viton, PTFE, and FFKM

MOC                  : SS 316, HAST-C Alloy – 20